PowerShield Centurion RT PSLCERT1000, Руководство пользователя

Страница: 5 / 25

4
www.powershield.com.au
1. Important Safety Warning
For safety reasons, it is essential to comply with all warnings and operating instructions listed
in this manual. Do not operate the UPS unit before carefully reading through all safety
information and operating instructions. It is recommended that you save and or backup this
manual for future reference.
1-1.
Transportation

Transport the UPS system using only the original packaging to protect against shock
and impact.

Handling Safety
Do not lift heavy loads without assistance.
This equipment is intended for installation in a controlled temperature indoor area free
from conductive contaminants.
1-2. Preparation

The UPS system must be absolutely dry before installation. As condensation may
occur if the UPS system is moved directly from cold to warm environments, allow at
least two hours for the UPS system to acclimate to the environment.

Do not install the UPS system near water or in moist environments.

Do not install the UPS system where it would be exposed to direct sunlight or near
heaters.

Do not block ventilation holes in the UPS housing.
1-3. Installation

Do not connect appliances or devices which would overload the UPS system (e.g. laser
printers) to the UPS output sockets.

To ensure against physical hazards, place cables safely such that persons cannot
accidentally trip over or step on them.

Do not connect domestic appliances such as hair dryers to UPS output sockets.

The UPS can be operated by any individuals with no previous experience.

Connect the UPS system only to an earthed shockproof outlet which must be easily
accessible and close to the UPS system.

Use only VDE-tested, CE-marked mains cable (e.g. the mains cable of your computer)
to connect the UPS system to the building wiring outlet (shockproof outlet).

Please use only VDE-tested, CE-marked power cables to connect the loads to the UPS
system.

When installing the equipment, ensure that the sum of the leakage current of the UPS
and the connected devices does not exceed 3.5mA.