PowerShield Centurion PSCE1000, Руководство пользователя

Страница: 10 / 24

www.powershield.com.au 9
Step 5: Disable and enable EPO ( Emergency Power Off ) function
Keep the pin 1 and pin 2 closed for UPS normal operation. To activate EPO( Emergency Power
Off ) function, cut the wire between pin 1 and pin 2.
Step 6: Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
Note : The battery charges fully during the first five hours of normal operation. Do not
expect full battery run capability during this initial charge period.
Unit will perform “Self test “ for 15 seconds and go to On line mode.
Note : Cold Start operation. When the UPS is off and there is no mains power, use cold
start feature to apply power to the connected equipment from the UPS’s battery. Cold
start is not a normal condition.
To cold start the unit, push and hold the ON/mute button until you will hear a long beep.
During the long beep, release the button and the unit will cold start.
Note : Unit is on battery mode therefore, the run time is limited.
Step 7: Install software
For optimal computer system protection, install NetGuard monitoring software to fully
configure UPS shutdown that is included in the package.
In order to install the software, insert provided NetGuard CD into CD-ROM to install the
monitoring software.
Please follow steps below to download and install monitoring software from the internet:
1. Go to the website http://www.powershield.com.au
2. Click PowerShield NetGuard software icon and then choose your required OS to download
the software.
3. Follow the on-screen instructions to install the software.
4. When your computer restarts, the monitoring software will appear as an orange plug icon
located in the system tray, near the clock.
It’s in closed status for UPS
normal operation.