POWX1350
EN
Copyright © 2021 VARO
P a g e
|
5
www.varo.com
5.
Move the drill bit forward up so it
lays in the ‘V’ guide and touches the metal end
stop (1c)
6.
Turn the drill bit until the
‘V’ guide fully drops over it (1c)
7.
All 4 drill bit corners should now be touching the
‘V’ guide sides.
8.
With the drill bit in this position, tighten the clamping ring, so
the drill bit can’t move
(1d)
9.
Lift up the ‘V guide and remove the clamp.
10. Transfer the clamp and drill bit into the clamp into the clamp holder on the Power
Unit module. (1e)
11. Switch the Power Unit on
12. Move the clamp holder from side to side, securing with light finger pressure (1f)
13. Remove the drill bit and holder and turn over (1g)
14. Move the clamp holder from side to side, securing with light finger pressure (1f)
15. Check the leading edge of both flutes are equally sharp. They should meet exactly
in the middle as in (1h) not (1i)
16. Switch the Power Unit off. Before removing the module, ensure the grinding wheel
has stopped.
7.2
Knife and scissor sharpener (Fig. 2)
Sharpens all straight edged knives and scissors
Unique top for sharpening knives
Precisely angled slot for sharpening scissors
SHARPENING KNIVES (2a-2c)
1.
Slide module ‘knife and scissor sharpener’ onto the power unit
2.
Switch the Power Unit on
3.
Hold the knife handle towards you and insert the blade into guide slot (2a)
4.
As soon as the blade touches the grinding wheel, draw it with light steady pressure
across the wheel. Do not press to hard (2b)
5.
Insert the second side of the blade into the other guide slot (2c) and repeat #4
6.
Repeat sharpening each side until a clean sharp edge is attained.
7.
Switch the Power Unit off. Before removing the module, ensure that the grinding
wheel has stopped.
SHARPENING SCISSORS (2d-2f)
1.
Slide module ‘knife and scissor sharpener’ onto the power unit
2.
Switch the Power Unit on
3.
Open the scissors fully
4.
Slide the first scissor blade through the front guide slot (2d). Keep the pivot of the
scissors and other blade to the right side.
5.
Draw the blade across the grinding wheel from pivot to tip. Use a light steady
pressure, do not press too hard (2e)
6.
Remove and turn the scissor over to sharpen the second blade (2f)
7.
Repeat if necessary, until clean sharp edges are achieved.
8.
Switch the Power Unit off. Before removing the module, ensure that the grinding
wheel has stopped
7.3
Chisel and plane sharpener (Fig. 3)
Regrinds chisel and plane blade up to 50mm wide
Adjustable grinding angle from 15°-50°
Powerful integral magnet to keep the blade secure
Protective shield for added safety
