POWDP25200
EN
Copyright © 2021 VARO
P a g e
|
9
www.varo.com
9.3
Setting the mitre angle (Fig. 6)
The mitre angle is infinitely variable between 0° and 45°.
▪
Loosen the lock lever for angle adjustment (2).
▪
Adjust the shoe to the desired angle between 0°to 45°.
▪
Tighten the lock lever for angle adjustment.
9.4
Mounting the parallel fence (Fig. 7)
The parallel fence allows sawing parallel to an edge at a maximum distance of 15 cm.
▪
Loosen the adjustment screw of guide bar (1).
▪
Slide the guide bar (15) through the slots in the base plate to the desired width.
▪
Tighten the adjusting screw to secure it in the position.
▪
Ensure that the guide bar rests against the wood along its entire length to give consistent
parallel cuts.
10 OPERATION
10.1
Instructions for use
▪
Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
▪
Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
▪
Hold the machine with both hands using both grips. This ensures optimum control over the
machine.
▪
For straight cuts along a drawn line use the marking for straight cuts.
▪
For bevel cuts along a drawn line use the marking for bevel cuts.
10.2
Switching on and off (Fig. 8)
Before engage the ON/OFF switch, check that the saw blade is properly
fitted and run smoothly, the blade clamp screw is well tightened.
▪
Connect the battery pack to the cordless circular saw and ensure it firmly.
▪
To switch the tool on, keep the lock-off button (5) depressed and press the on/off switch
(6).
▪
To switch the tool off, release the on/off switch.
10.3
Dust extraction
A vacuum cleaner can be connected to the dust extraction outlet, either directly to the
connector or using an adapter.
▪
If necessary, connect an adapter to the extraction outlet.
10.4
Cross-cutting
When making a cross-cut or a rip cut, align the guideline with the blade-guide notch on the
base. Since blade thicknesses vary, you should always make a trial cut in scrap material along
a guideline to determine how much the guideline must be offset from the guide to produce an
accurate cut.
NOTICE: The distance from the cutting line to the guideline is the amount by which the guide
should be offset. Use a guide when making long or wide rip cuts.
10.5
Bevel cutting
▪
Align the line of cut with the 45° blade guide notch on the base when making 45° bevel
cuts.
▪
Make a trial cut in scrap material along a guideline to determine how much you should
offset the guideline on the cutting material.
