POWDP20100
EN
Copyright © 2021 VARO
P a g e
|
7
www.varo.com
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
▪
Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
▪
Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
−
Carefully wipe the liquid off using a cloth. Avoid skin contact.
−
In case of skin or eye contact, follow the instructions below:
✓
Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.
✓
In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
7.2
Chargers
▪
Never attempt to charge non-rechargeable batteries.
▪
Have defective cords replaced immediately.
▪
Do not expose to water.
▪
Do not open the charger.
▪
Do not probe the charger.
▪
The charger is intended for indoor use only.
8 FEATURES
8.1
Li-ion battery (6)
Advantages of Li-ion batteries:
▪
Li-ion batteries have a higher capacity/weight ratio (more power for less heavy, more
compact, battery).
▪
No memory effect (capacity loss after several charge/discharge cycles) like other type
batteries. (Ni-Cd, Ni-MeH,...).
▪
Limited self-discharge (also see chapter: Storage).
8.2
Forward/reverse selector (right/left rotation selector) (3)
Your tool has a forward/reverse selector located above the switch trigger.
CAUTION: To prevent damage to the gearbox, always allow the chuck to come to a complete
stop before changing the direction of rotation or selecting another speed (HI-LO). To stop,
release the trigger switch.
8.3
Variable speed
Your tool has a variable speed switch. The rotational speed and torque will in-/ decrease
equivalently to applied trigger pressure.
8.4
LED work light (8)
Your tool is equipped with 3 LED lights at the front.
8.5
Speed setting
This tool has a button to adjust the speed and torque. With the speed setting button (13) you
can select 3 ranges.
