4
5
4.USING THE
“BOOSTER” FUNCTION WARNING
Ensure that you are using this on a 12 VOLT SYSTEM ONLY,
otherwise the battery could explode. Please strictly follow
the following steps, otherwise, it could cause damage to
the jumpstart, the vehicle or personal injury and death!
USING JUMP START OPERATION STEPS
4.
USING THE
“BOOSTER” FUNCTION WARNING
Understand your JUMPSTART
①
Turn ignition to
ON
and ensure all onboard electronics is off.
②
DO NOT allow both (RED & BLACK) clamps to contact each
others.
③
If clamps are hooked up in wrong polarity, safety alarm will
activate. Onboard relay will be disabled for safety and no
power will be provided.
④
Only use on vehicles with a 12V system.
⑤
If JUMPSTART is used under cold weather (< -
25˚C), you may
require to start car a few times more than normal.
⑥
Under low temperature (< -
10˚C/14˚F),performance of LiPo
battery is
deeply affected. After a few attempts to generate
Power should warm up the Jump Start, make it work again
⑦
If car doesn't start; wait 1 minutes before attempting to restart.
If car can't start more than 5 times,
STOP
and seek other help.
⑧
Disconnect both clamps immediately once car starts.
⑨
After each use, always recharge the JUMPSTART battery fully.
There is no power at the output ports during charging.
Step 5
Step 6
Once car started successfully
Remove the clamps
Ground
Ground
1
2
Once car started, press power
Make sure the Jump start is off, then
button to turn off the JUMP START
①
First to remove the black clip (-)
power.
②
Next to remove the red clip (+)
Step 1
Press Power button
OR
B
A
2
1
2
- +
Ground
LCD displays the voltage and capacity
of device battery, must be >11.5V for
best results. Firmly insert the end of
the cable into the JUMP START. (First
time use might feel some resistance to
be pushed in all the way.)
Step 2
Hookup the car battery
OR
B
A
-
+
Ground
Put the black clip (-) terminal attach to
the battery negative post or chassis
ground, put the red clip (+) terminal
attach to the battery negative post.
* Alarm will beep if polarity is wrong.
** If car battery is completely dead,
Go
to Step 3B
.
Step 3A
Ready to crank the car
OR
B
A
-
+
Ground
Press JUMP START button to initiate
boost function.
-
＋
Indication: the
-
＋
is highlight
Go to Step 4A
Step 4A
OR
B
A
Starting the car
- +
Ground
-
＋
Make sure the
is highlighted and
battery status > 11.5V. Start the car
and should see 14.1V as indicated. If
start failed, repeat Step 3A process
again. Seek other help if start process
has been repeated > 5 times. pushed
in all the way.)
-
＋
Step 3B
This applies to DEAD battery (<4V)
situation ONLY.
Hold & press JUMP START button
for 3 sec to initiat e
“
phantom"
polarity check. If polarity is wrong,
the alarm will sound.
Go to Step 4B
Step 4B
Safety check will take up 30 sec long
-
＋
the will flash continuously; then
Power will be ready for starting.
Correct the polarity if it is wrong. If
start failed, repeat Step 3B process
again. Seek help if start process has
been repeated > 5 times.
