Powermatic PM1900, Инструкция и каталог запасных частей

Страница: 9 / 20

9
2. Align the top holes of the support bar (W) with
the holes at the rear of the collector housing (V)
and insert two screws (A) and two flat washers
(D).
3. Place a washer (D) and a hex nut (F) on the
protruding end of each screw (A) inside the
collector housing, and hand-tighten only.
4. Adjust the lower part of the support bar (W) as
needed using its slots, until it is straight. Then
tighten all four screws on the
support bar (W).
5. Repeat for the other support bar.
Handles
1. Remove the plate (Y) from the handle (X) by
loosening the two socket head cap screws (Z)
with a 6mm hex wrench.
2. Install handle (X) to the holes in the collector
housing (U) by inserting the socket head cap
screws through the handle, the collector
housing, and into the plate on the opposite side.
Tighten the screws.
Note: Make sure the plate (Y) is oriented
properly, as shown in the Detail in Figure 1: The
protrusions on the plate should face away from
the handle.
3. Install the other three handles in like manner.
(Two handles for each housing.)
Filter System
If your PM1900 Dust Collection system includes filter
bags, proceed to
Filter Bag System Assembly on
page 10.
If your PM1900 Dust Collection system includes the
canister kit, proceed to
Canister System Assembly on
page 11.
Figure 2: Assembly and part identification