PRE-START PREPARATION
Before starting the pressure washer, check for loose or missing
parts and for any damage which may have occurred during shipment.
Handle Installation
Remove the handle by pressing the handle release buttons. Turn
the handle around and insert back into the carrier, pushing down until
the handle release buttons lock into place (see figure 1).
START-UP PROCEDURE
1.
Make sure water supply is connected and turned on.
2.
Release gun safety if locked.
3.
To allow air to escape from the hose, squeeze trigger on
the gun until there is a steady stream of water coming
from the nozzle.
4.
Remove any dirt or foreign matter from the gun outlet and
the male connector of the wand.
5.
Insert the nozzle wand into the gun wand and tighten the
fitting securely.
STARTING THE ENGINE
1.
Check oil and fuel level.
2.
Set the engine switch to the “ON” position.
3.
Push the primer as necessary.
4.
Squeeze trigger on pressure washer to release pressure
while pulling on the engine starter rope with a fast steady
pull. Pressure may otherwise build up making starting the
unit difficult.
HIGH PRESSURE HOSE
Attach the high pressure hose to the fitting located on the front
side of the side panel (outlet connection). Only high pressure (2700
PSI) pressure washer hoses should be used.
WATER CONNECTION
Before connecting the inlet hose to the unit, run water through
the garden hose (not supplied) to flush out any foreign matter. The
inlet hose will be connected to the fitting (Figure 2) .
The high pressure nozzle position is intended for cleaning.
When high pressure is required, grasp collar and slide the collar and
nozzle toward the gun.
NOTE: Make sure the nozzle cover is pulled to the extreme
rear position to lock the nozzle in the high pressure position.
When low pressure is required, grasp and slide the nozzle cover
away from the gun.
The adjustable spray nozzle can adjust spray from fan to pencil
point in both the high and low pressure positions. The spray is
adjusted by turning the nozzle cover.
CAUTION: The pencil point spray adjustment is very
aggressive. We recommend that for most cleaning
applications, a twenty degree (20°) spray angle be used
to avoid damage to the surface being sprayed.
START-UP PROCEDURE
OPERATING CONNECTIONS
English
Figure 1
Figure 2
5
HIGH PRESSURE/LOW PRESSURE
ADJUSTABLE SPRAY NOZZLE
Low Pressure
High Pressure
Pin Point Spray
To decrease angle to a pencil point
spray, turn clockwise.
FanSpray
To increase angle to a fan spray,
turn counterclockwise.
