Powermate PP0100363, Руководство пользователя

Страница: 11 / 20

Owner’s Manual for Water Pump 9
Starting the Engine
1. Remove water priming plug and fill the
pump with water. Replace water priming
plug.
2. See Figure 3-2. Move fuel valve lever (A)
to ON position.
Figure 3-10. Starting the Engine
3. Move choke lever (B) to CLOSED position.
NOTE : For warm engine, leave choke lever in
OPEN position.
4. Move throttle lever (C) about 1/3 away
from the MIN position.
5. See Figure 3-3. Turn engine switch (D)
ON.
Figure 3-11. Engine Switch
..
Figure 3-12. Engine Recoil
6. Grasp recoil handle (E) and pull slowly
until you feel some resistance. Then pull
rapidly to start engine. Return recoil
handle slowly. DO NOT let recoil snap
back against recoil housing.
7. When engine starts, slowly move choke
lever to OPEN position as engine warms.
If engine falters, move choke lever to
CLOSE position, then to OPEN position.
If engine fails to start after six pulls, move
choke lever to “OPEN” position, and repeat
step 6.
8. When the engine is running smoothly,
adjust the throttle lever to set the desired
engine speed.
.
Preventing Water Hammer
Water hammer occurs when the discharge
flow is suddenly blocked or stopped.
Pressurized water trapped inside the pump
can crack the pump housing. To prevent water
hammer:
• Do not close the discharge valve while the
pump is operating.
• Do not allow vehicles to drive over the
discharge hose.
• Do not abruptly compress the discharge
hose.
Water Pump Shut Down
1. Move throttle lever from fast to slow.
2. Turn engine switch OFF.
3. Move fuel valve lever to OFF position.
4. Allow the engine to cool thoroughly.
(000203)
CAUTION
Equipment damage. Before starting engine, verify
pump is primed with water and suction strainer is
submerged. Failure to do so will cause pump damage
and void the warranty.
000841
A
B
C
C
OFF
ON
000128
D
000823
E
(000113)
WARNING
Recoil Hazard. Recoil could retract unexpectedly
if water pressure is not properly relieved from
pump, creating kickback. Kickback
could result in death or serious injury.
(000110)
WARNING
Risk of Fire. Hot surfaces could ignite
combustibles, resulting in fire. Fire could result
in death or serious injury.
(000108)
WARNING
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces
could result in severe burns or fire.