Powermania Turbo M212V2, Руководство по эксплуатации

Страница: 19 / 25

18 www.powermaniausa.com
Troubleshooting
TROUBLESHOOTING
DANGER:
ALWAYS DISCONNECT AC POWER CORD PRIOR
TO MAKING ANY DC WIRING CONNECTION
CHANGE OR WHEN CHECKING FUSES.
Problem Possible Cause Solution
Power indicator is
not on.
No AC input.
Check AC input connection. Make sure AC
power is present.
Short circuit at DC
output.
Check and correct battery wiring connection
(Refer to wiring connection charts). Replace
broken fuse if necessary.
Over-Voltage
warning indicator is
on (amber) Battery voltage
exceeds safe
range.
Check and correct battery wiring connec-
tion. (Refer to wiring connection charts.)
Make sure each output is connected to one
12V battery. Wait at least 30 seconds before
plugging in AC power again.
If Over-Voltage LED continues to be on even
with correct wiring connections, unplug the
charger’s AC power input and stop using
the charger to avoid possible damage to the
battery and/or connected devices.
Overheat warning
indicator LED is on
(amber) Ambient tempera-
ture exceeds safe
range.
Remove objects obstructing airflow around
the charger. If the charger was operated un-
der direct sunlight, move it away from direct
sunlight exposure. Charger will wait for the
temperature to come down, then automati-
cally start again.
Charge Status /
Connection Check
LED displays amber
The output cable is
not connected to a
12V battery. Properly connect the DC output to a 12V
battery. Refer to wiring connection charts.
Fuse failure.
Check for blown fuses on the output cables.
Replace damaged fuses.
Faulty terminal
connections.
Clean battery terminal and tighten all wiring
connections.
Reverse polarity on
DC wiring connec-
tions. Make sure connections have a matching
polarity. Check fuses on output cables and
replace any damaged fuses.
Damaged battery.
Perform battery test. Replace damaged
batteries.