PowerLand PDST24, Руководство пользователя

Страница: 7 / 28

7
Attaching the Chute Assembly and Directional Control
1. Install the chute to the correct holes of outer shell's
back.
2. Use the bolt and nut to fix the chute and bearing to
the support base of chute.
3. After install the chute direction control,then make it
drill through rotary shaft,let the chute direction
control istall to the chute.Use nut to fix the chute
direction control to the chute,and istall one gasket
to the chute raised step.
NOTE:
If necessary, the lower bracket can be
adjusted. Refer to Chute Bracket Adjustment
CAUTION:
Prior to operating your snow
thrower, refer to Auger Control Test
Read and follow all instructions carefully and
perform all adjustments to verify your snow
thrower is operating safely and properly.
Tire Pressure
• Before operating, check tire pressure and reduce
pressure in both tires to between 15 psi and 20 psi.
NOTE:
If the tire pressure is not equal in both tires,
the unit may not travel in a straight path and the shave
plate may wear unevenly.
4. Install the plum-plastic-head bolt,locked equipment
bush,locked equipment stress blockand spring to the
throwing snow-rotating-shaft. Screw down the plum-
plastic-head bolt,make the locked equipment stress
block and regulating-rod of chute tightness combined,
and press the throwing snow-rotating-shaft.
NOTE:
The detailed instruction is attached in User's Manual.