17
Troubleshooting
Most difficulties are easy to fix. Consult the troubleshooting table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor adjustments, please call 1-866-SNOWJOE (1-866-766-9563)
for assistance.
Little or no material flow
a)
Nozzle clogged.
b)
Suction tube clogged.
c)
Material volume setting turned too low.
d)
Suction tube loose.
e)
No pressure build up in container.
f)
Air filter clogged.
a)
Clean the nozzle with the supplied
needle clean-out tool.
b)
Clean the suction tube with the supplied
cleaning brush.
c)
Increase the spray amount by adjusting
the flow control knob.
d)
Tighten the suction tube.
e)
Tighten the
paint container.
f)
Clean the air filter.
Problem
Possible Cause
Solution
Material leaking
a)
Nozzle is loose.
b)
Nozzle is worn.
c)
Suction tube loose.
d)
Material builds up and blocks the air
cap and nozzle.
a)
Insert the nozzle tip securely.
b)
Replace the nozzle.
c)
Tighten the suction tube.
d)
Clean the blocked air cap and the nozzle.
The spray is not fine
a)
Viscosity of material is too high.
b)
Spray tip orifice is too large.
c)
Material volume setting too high.
d)
Nozzle clogged.
e)
Air filter clogged.
f)
Too little pressure build-up in container.
a)
Thin the material properly.
b)
Change to a smaller nozzle tip.
c)
Decrease the spray amount by adjusting
the flow control knob.
d)
Clean the nozzle with the supplied needle
clean-out tool.
e)
Clean the air filter.
f)
Tighten the
paint container.
Cannot generate
continuous spray
a)
Material in the spray container is
running out.
b)
Air filter is clogged.
a)
Refill the container.
b)
Clean the air filter.
Paint runs or drips on
the surface
a)
There's too much paint applied on
the surface.
a)
Decrease the spray amount by adjusting
the flow control knob.
b)
Move fast with the sprayer.
Too much overspray
a)
The sprayer is too far from the surface.
b)
There's too much paint applied on
the surface.
a)
Reduce the distance.
b)
Decrease the spray amount by adjusting
the flow control knob or move quickly with
the sprayer.
Paint is light and not even on
the surface
a)
The sprayer is moved too fast during
spraying.
a)
Increase the spray amount by adjusting
the flow control knob or move slower with
the sprayer.
Содержание 24V-PS1
Страница 20: ...snowjoe com ...
