Powerhorse 190555, Руководство пользователя

Страница: 5 / 24

5
WARNING:
Avoid “kickback” by knowing what conditions can create it. Kickback may occur
when the nose or tip of the guide bar touches an object, or when the wood closes in and pinches the saw
chain in the cut. Tip contact in some cases may cause a lightning fast reverse reaction, kicking the guide
bar up and back towards the operator. Pinching the saw chain along the top of the guide bar may push
the guide bar rapidly back towards the operator. Either of these reactions my cause you to lose control of
the saw which could result in serious personal injury.

Remove adjusting keys or wrenches before starting the chain saw. A wrench or key that is left
attached to a rotating part of the chain saw may result in personal injury.
INTERNAL COMBUSTION ENGINE SAFETY
WARNING:
Internal combustion engines present special hazards during operation and fueling.
Read and follow the warning instructions in the engine Owner’s Manual and the safety guidelines below.
Failure to follow the warnings and safety standards could result in severe injury or death.

DO NOT run the chain saw indoors or in an enclosed area such as a deep trench unless
adequate ventilation, through such items as exhaust fans or hoses, is provided. Exhaust gas
from the engine contains poisonous carbon monoxide gas; exposure to carbon monoxide can
cause loss of consciousness and may lead to death.

DO NOT smoke while operating the chain saw.

DO NOT smoke when refueling the chain saw.

DO NOT refuel a hot or running chain saw.

DO NOT refuel the chain saw near an open flame.

DO NOT spill fuel when refueling the chain saw.

DO NOT run the chain saw near open flames.

ALWAYS refill the fuel tank in a well-ventilated area.

ALWAYS replace the fuel tank cap after refueling.

ALWAYS check the fuel lines and the fuel tank for leaks and cracks before starting the chain
saw. Do not run the chain saw if fuel leaks are present or the fuel lines are loose.

ALWAYS avoid contact with hot fuel, oil, exhaust fumes and solid surfaces.

Never touch the engine or muffler while the engine is on or immediately after it has been turned
off. These areas get hot and may cause burns.

Move the chain saw at least 10 feet from fueling point before starting the engine.
NOTE: All Federal and State laws and any regulation having jurisdiction covering the safety
requirements for use of the chain saw take precedence over the statements in this manual. Users of
this chain saw must adhere to such regulations.