> >Unit settings
> > >um
> > >mils
> > >mm
> > Backlight
> > >ON
> > >OFF
> > LCD Statistic
> > >Average
> > >Maximum
> > >Minimum
> > >Sdev.
> >Auto power off
> > >Enable
> > >Disable
>Limit
> >Limit settings
> > >High limit
> > >Low limit
> >Delete limit
> Delete
> >Current data
> >AII data
> >Group data
>Measurement view
>Calibration
> >Enable
> >Disable
> >Delete Zero N
> >Delete Zero F
2-3-2 Basic Settings
Please refer to the MENU arrange. According to the LCD indication,
Press red-bar button for OK/YES/MENU/SELECT operating functions.
Press blue-bar button for ESC/NO/BACK operating functions. Press the
UP/DOWN button to switch the selected item.
2-3-2-1 Measure mode
-Continuous measurement mode: It can sometimes be of advantage if
the probe does not need to be raised between each measurement so
that there is a running display of readings. In continuous mode, readings
are not accompanied by a bleep. All readings taken in this mode will
automatically be entered into the statistics program as long as sufficient
memory is available.
-Single mode: In Single mode. readings are accompanied by a bleep.
Besides, Others are same as Continuous measurement mode.
2-3-2-2 Used probe
The probe can work in three modes.
AUTO
: The probe can automatically select the working mode. When
Placed on steel (magnetic substrates), it will work in magnetic induction
principle. When placed on no-ferrous metals, it will work in eddy current
principle.
Fe
: The probe works in magnetic induction principle.
No-Fe
: The probe works in eddy current principle.
2-3-2-3 Unit settings
You can switch from Metric units
(µm,
mm) to imperials (mils).
In “
µm “
mode, the unit will switch to "mm" automatically when value of
reading exceeds 850um, see the specification section for more details.
