Powergen Digit 3001, Инструкция по эксплуатации

Страница: 15 / 26

I
NSTRUCTIONS
M
ANUAL
D
IGIT
3001
R
ELEASE
. N.2_M 13_10_08
P
OWERGEN
S.
R
.
L
. V
IA
XXV A
PRILE
, 5 L
OC
. C
ORSALONE
C
HIUSI DELLA
V
ERNA
(A
REZZO
)
)
+39-(0)575-531015 - T39-(0)575-511891 E mail borri@elledi.it
www.batterychargerpowergen.it P.Iva 01572290516 - 15 -
Once the charging cycle has started, it can be manually interrupted by pressing the left-
hand “ ON/OFF ” button. “ StoP ” will be shown on the display. By pressing the
left-hand " ON/OFF " button again, the charging cycle will be enabled. This will be started
again automatically after 5 seconds. The cycle will resume from where it stopped.
The display menu is also available during the cycle interruption. By pressing the middle
"
A/V " button, the User will be able to browse the display menu and to scroll and read the
following charging parameters:
-
charging current in real time: “ A. XXX ”;
-
battery voltage in real time: “ U.XXX ”;
- voltage per cell in real time: “ E.XXX ”;
-
Total time of performed charge: “ t.XXX ”;
- charging time of performed timed cycle : “ F.XXX ”;
-
delivered capacity (ampere-hours integrated into the battery): “ AH. ” “ XXXX ”. The
value is shown in two subsequent displays. Display “ XXXX ” is shown automatically
after about 1 second from display “ AH. ”
Should mains voltage fail during the operation of the charging cycle, this will be interrupted
and “ StoP ” will be shown on the display. Once mains voltage is restored, the
cycle will start again automatically after 5 seconds from where it stopped.
In case of battery disconnection during the charging cycle, this will be interrupted and
“ UMIn ” will be shown on the display first and then “ bdIS ” . As soon as
the battery is reconnected, the cycle will resume its operation from the start ( initial charge ),
setting to zero the active time meters, if any. “ StoP ” and then “ nor ”
will be shown on the display.
If the battery cable is disconnected when the cycle has finished or has not yet started,
“ UMIn ” will be shown on the display.
8.2.2. LED bar
During the charging cycle, the card will not only control the display of charging parameters,
but also the switching on/off of the LED's on the front panel (see General Description)
based on the following sequence:
in case of mains and battery present, before the cycle starts automatically, the second
LED "
battery connected " will be steadily lit. Once the charging cycle has started ( initial
charge ) the same LED will start blinking. Once the battery threshold voltage is reached,
the third LED " timed cycle " will be steadily lit and after three minutes the timed charging
cycle will start and the LED will start blinking. After the time set in the timed cycle has
elapsed, the charging cycle will be completed and the fourth LED " charge completed " will
be steadily lit (the second one will remain steadily lit and the third one will be off).