Powerfix Profi 289710, Инструкция по сборке, эксплуатации и безопасности

Страница: 8 / 39

8 GB/CY
Verify the work pieces/sheet will not move on the top support
bar
8
. If necessary, secure in place.
Make sure that you do not load workpieces unevenly. Otherwise,
the workpiece can become unbalanced and fall down.
Remove any excess materials on the product, e.g. wet paint, dirt, oil or snow.
Installation
Note: To begin the assembly, please be reminded to only tighten all screw con-
nection slightly, and only tighten fully the screw connection when the product is
assembled completely.
First spread the leg of side frame
5
. Pull down the locking pin
10
on the leg
and lock the locking hook
12
on the other leg. Insert the hole bar
7
through
the middle part of side frame
5
. Use the locking pin
10
and insert through
the hole on the side frame
5
in order to lock the hole bar
7
in place. Please
be reminded to leave at least 3 holes to be protrude on top of the frame. Re-
peat the above steps to have 2 side frames with support bar (Fig. A).
Make sure both hole bars
7
are on the same height.
Connect the middle support bar
9
and use screw sets
1
and
2
to connect
with both side frames
5
(Fig. B).
Use screw set
2
on the side where is the locking hook
11
on the leg. After
you finish connect screw set
2
, pull down the locking hook
11
and lock the
hooks on the screw. Use the screw sets
1
on the other side. Repeat the above
steps to fix the middle support bar
9
in place (Fig. C).
Connect the bottom plate
6
to the leg with screw set
3
. Repeat the above to
fix both bottom plates in place (Fig. D).
Place the top support bar
8
onto the hole bar
7
. Use screw sets
4
to fix
the top support bar
8
in place (Fig. E).
Align the product and tighten all the screw connections
Raise the two safety brackets
13
on the top support bar
8
(Fig. F).
Use
CAUTION! RISK OF INJURY! Be sure locking hooks
11
und
12
are
secured in place. The two trestles must be set to the same working height. This
will ensure stability.
Verify the work pieces/sheet will not move on the top. If necessary, secure in
place.
Make sure that you do not load workpieces unevenly. Otherwise, the work-
piece can become unbalanced and fall down.
Always use two trestles and a board or boards together for working.
Fold the legs all the way apart.