V4.0
20 in. Misting Wall/Floor Fan
8908519
Visit www.princessauto.com for more information
9
3. Adjust the fan head’s tilt angle by loosening the bracket knob (B)
holding the fan head to the wall bracket. Tighten the knob when the
angle is correct.
4. The fan has three speeds and an OFF setting. Each pull of the string
increases the speed setting one step from OFF, Low, Med, High and
back to OFF.
5. Once the speed is chosen, open the faucet to supply water to the
misting ring (I).
6. Before stopping the fan, turn the faucet off and disconnect the hose
from the faucet to let the water drain out. Allow the fan to blow for a
short duration to dry the misting ring nozzles.
7. Pull the string to shut the fan off.
8. Unplug the fan and store in a dry environment after use.
CARE & MAINTENANCE
WARNING! Never clean the device while connected to a power source. Doing
so may cause an electric shock. Always unplug the fan before cleaning.
1. Maintain the device with care. A device in good condition is efficient,
easier to control and will have fewer problems.
2. Inspect the device components periodically. Repair or replace damaged
or worn components. Only use identical replacement parts when
servicing.
3. Maintain the device’s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
4. Do not unseal the motor. It does not require any interior maintenance or
cleaning. The Internal motor bearings are permanently lubricated at the
factory and do not require any additional lubrication.
5. The fan has a fuse to protect it from an overload. Replace the fuse with one
of the same amperage. If the new fuse also blows, there is likely a short-
circuit in the system. Remove the fan from service and have it repaired.
WARNING! Only qualified service personnel should repair the device. An
improperly repaired device may present a hazard to the user and/or others.
