PowerBox Systems PowerBox Competition SRS, Инструкция по эксплуатации

Страница: 13 / 36

-13-
• Jeti Duplex EX:
The digital signal employed by Jeti is substantially faster and more
accurate than a PPM signal. The R-SAT2 satellites must be loaded with
software version 3.11 or later in order to be able to switch the EX signal
on. Set the following points in the sequence stated below:
- Output mode: PPM Positive
- No. of channels: 16 channels
- Output mode: EX Bus
- Output period: Auto
- Failsafe: Disabled
Note: in the case of the R-SAT2 the EX signal must be connected to the
EXT output - not to PPM-out. A more detailed description of the
procedure can be found in the Support Forum on our website, including
information on the subject of telemetry.
• JR DMSS:
In the case of the JR DMSS system you must use a receiver with X-Bus
output. This is the procedure:
- Connect the Bind plug to receiver 1
- Move to the “SYSTEM LIST” menu at the transmitter, and select “BIND
& RANGE”
- Select the “BIND” point, and wait until the LEDs light up green
- Move to the “X-BUS” point in the menu, and select “MODE.A”
If you are using two receivers, disconnect the first one at this point and
repeat the procedure with the second receiver. A more detailed
description of the procedure can be found in the
Support Forum on our
website.