PowerBoss Nautilus Hi-Dump PB45HDSL, Сервисная книжка, Страница: 52 / 117

52
ADJUSTMENTS & PROCEDURES
NAULTILUS SCRUB BRUSH FLOOR PRESSURE ADJUSTMENT
The unit must be on to input settings.
Turning the right control knob scrolls through the parameters listed above.
Turning the left control knob changes the settings of each parameter.
The settings are saved by turning the right control knob to SA and rotating the left control knob one full turn (in either direction).
CONTROLLER SETTINGS:
Set P1 to 1.48 A Providing 200 lbs of brush pressure against the floor (415 psi at port BLB)
Set P2 to 1.98 A Providing 300 lbs of brush pressure against the floor (730 psi at port BLB)
Set P3 to 2.18 A Providing 400 lbs of brush pressure against the floor (865 psi at port BLB)
P4 – Not used
Set UP to 00.5 SEC
Set DN to 00.5 SEC
Set Df (dither) to 250 Hz
dI = screen orientation – no setting should be required.
SA (save settings) – Turn the left control knob one full turn (in either direction).