PowerBoss Nautilus Hi-Dump PB45HDSL, Сервисная книжка

Страница: 117 / 117

CHANGING SOLID TIRES
NOTE: The procedures that follow apply to SOLID TIRES ONLY.
Front Tire:
1. Remove the tire from the vehicle by removing the 5 lug nuts.
2. Press the tire from the rim.
3. Press the new tire onto the rim.
4. Reinstall the tire on the machine
5. Tighten the five wheel lug nuts to 90 – 110 ft lb (120 – 150 Nm)
Rear Tires:
1. Remove the tire from the vehicle by removing the center axle nut.
2. Pull the rear tire straight off of the axle.
3. Remove the inner and outer bearings. Note which is the inner bearing and which is the outer
bearing so that they are reinstalled in the same location.
4. Press the tire from the rim.
5. Press the new tire onto the rim.
6. Clean the inner and outer bearing races and bores
7. Clean the bearings. Inspect the bearings and races for wear, replace if necessary.
8. Grease the bearings with Lubriplate EMB or equivalent.
9. Install the bearings in the wheel. Insure that the bearing seals are seated correctly and being
careful not to get any grease on the brake surface or brake pads.
10. Reinstall the tire on the machine by holding the wheel parallel to the side of the vehicle and
firmly push it onto the axle.
11. Torque the wheel nut to 100 in-lb (11.3 Nm)
12. Align the hole in the axle with the closest slot on the nut and install the cotter pin.
13. Install the hub cap