29
Operation
3.3.6
After finishing work
1. Operate the shaking device.
2. Empty the dirt hoppers.
3. Check the brush area for any residu-
al waste and remove it if necessary,
refer to Section “Cleaning the brush
space“.
4. Clean the machine, if necessary.
Warning - do not clean electri-
cal components with liquids!
Risk of electric shock!
It is not permitted to clean the
machine with a pressure wash-
er or steam blaster.
Operating the shaking device
Push and pull the lever (Fig.
8/6)
in
and
out several times in succession to clean
dust from the panel air filter.
Only operate the shaking de-
vice when the engine is
switched off.
Emptying the dirt hoppers
1. Move the locking lever (Fig.
8/8) to
the right (looking to the front) and, at
the same time, tip the handlebar
(Fig.
8/2) to the front.
2. Remove the dirt hoppers (Fig.
12/2)
from the machine and empty them.
Carry the dirt hoppers
(Fig.
12/2) by the handles
(Fig.
12/1).
Fig.
12
Observe the applicable laws
and local regulations when dis-
posing of waste.
3.3.7
Loading and transportation
When loading the machine and
transporting it to its area of de-
ployment, the side brush must
be raised.
Loading
When loading the machine, take its
weight and climbing capacity into ac-
count, refer to paragraph ”Technical
Data”.
Transporting
The machine must be properly
secured. It must not slip or tip
during transportation! Risk of
injury!
When transporting on a vehicle or trail-
er, the machine must be secured
against rolling away: Actuate the park-
ing brake and lash down the machine
securely at the front and rear.
2
1
2
