P
OWERBOND
Art.Nr. 9109
8
-
As soon as the gun has warmed up, open cover (no. 11) by turning the star grip (no. 18) to the left. Load
selected glue.
-
Fill tank only up to approx. 1.5 cm below upper rim. To close the cover turn grip to the right.
-
Allow approx. 3 - 10 minutes, depending on quantity and type of glue, for the gun to melt the glue.The
quantity to be applied can be determined by pressing the trigger (no. 31); the longer you press, the more
glue comes out.
Application of Hot Melts
Make yourself familiar with the instrument first. Apply a little glue in varying forms (small, large dots) on a
piece of paper or cardboard. This is very easy. Try to find out the correct quantity and the ideal pattern by
adjusting the pressure controllers at the stand to different pressures.
Observe the correct working temperatures of the individual hot melt.
Never start working without having mounted a nozzle!
Nozzle Replacement
Only replace nozzles when the glue gun is warm (instrument temperature 60 - 80°C / approx. 140 - 175 °F)
and empty. For the replacement you need a SW 13 open-end spanner. You are advised to wear gloves.
Prior to exchanging nozzles, unplug connecting cable!
Replacing a cold nozzle may damage the gun. If the nozzle is replaced when it is too hot, liquid adhesive
may leak out.
Warning: Risk of burning!
-
When your skin got into contact with hot glue, immediately cool it with cold water.
-
Do not try to remove hot melt from the skin first. If necessary consult your doctor.
-
When hot adhesive got in your eyes, immediately cool them under running water for about 15 minutes.
Consult your doctor at once!
Never start working without having mounted a nozzle!
Do not direct glue jet towards people!
Working with Stationary Equipment
(in connection with pneumatic foot switch)
To work with stationary equipment mount glue gun and foot switch according to enclosed drawings
„Connection of Foot Switch“ and „Stationary Equipment“. Then, proceed as follows:
-
Press trigger (no.31) down to stop and hold it
-
Plug enclosed screw into the borehole provided for this purpose at one side of the casing handle
-
Let trigger loose
-
Trigger is locked
