P
OWERBOND
Art.Nr. 9109
10
Note: - Do not lay gun on its side
-
Fill tank only up to max. 1.5 cm below upper rim
- Gun must de-aerate audibly
- Always de-aerate before lid is opened
- Do not direct glue jet towards people
- Do not hold nozzle top upwards
- Never work without having mounted a nozzle
- Do not carry out overhead work
- Stop using the instrument, if casing is damaged due to shock, breakage or heavy wear.
Even if the gun has been switched off, it may be under pressure and glue might flow out!
When using the stand, remove wire strap!
Cleaning and Maintenance
Only fill clean glue into the premelting tank. Contaminated glue, nails, clamps, sand, etc. cause malfunctions.
If you observe the operating instructions, the gun does normally not need cleaning. The glue remaining in
the gun will remelt when it is warmed up and can be used for glueing again.
The glue must not get too hot, otherwise it may coke (hot melts on a polyamide basis are particularly
sensitive). If this has happened, the gun should be cleaned with Powerbond cleaning liquid.
If the gun is used very often, it has to be maintained regularly. To set a date, please call our service depart-
ment.
Additional Information
Do you have any more questions or requests? We should be glad to help you.
Please contact us at phone no. ++44 (0) 1782 823874 or fax no. ++44 (0)1782 837038
Our mailing address is:
Powerbond Adhesives Ltd
253 Scotia Road
Tunstall
Stoke on Trent
Staffordshire
ST6 6AB
England
e-mail: [email protected]
Internet: www.powerbond.co.uk
