PowerBass STA-8, Руководство пользователя

Страница: 4 / 20

SPECIFICATIONS FOR STA-8 SUBWOOFER SYSTEM
(Due to Constant Improvements, Specifications and Parameters are subject to change without notice.)
Size System
Impedance
Frequency
Response
Sensitivity
1W/1M
Magnet
Size
Voice Coil
Dia.
Low Level Input
Sensitivity
High Level Input
Sensitivity
Amp Power
RMS/Peak
Single 8” 2-ohm 20Hz-200Hz 91dB 30 oz. 1.5” 250mV - 6V 1.0V - 10V 150W/300W
UNPACKING THE ENCLOSURE
Every attempt has been made to transport your new PowerBass STA subwoofer system safely. Carefully
unpack the enclosure and inspect it thoroughly for any damage that may have occurred during shipping. Notify
your local PowerBass dealer immediately should you notice any damage prior to installing the unit. Be sure to
keep the carton and packing material until your system is operational. The original boxes will do the best job
of protecting your speaker system if they need to be transported.
INSTALLATION EXPERIENCE
Installation of PowerBass Autosound Speakers requires experience with a variety of mechanical and electrical
procedures. This manual only provides general installation and operating instructions. If you have any reserva-
tions about your installation skills or lack the proper tools, please contact your local PowerBass Autosound
dealer for assistance.
IMPORTANT: This amplified subwoofer system is designed for operation in vehicles with 12-volt
Negative ground electrical systems only.
ENCLOSURE PLACEMENT TIPS & RECOMMENDATIONS
Your Powerbass Amplified Bass system must be properly placed in the vehicle for optimum performance.
Find a spot under your seats where the enclosure will not get in the way of any moving parts of the seat.
Make sure that the seat moves freely if it is adjustable.
Ideally there should be enough room around the enclosure which is also a heatsink for the amplifier so it
can remain cool.
WARNING: Make sure where ever you choose to place the enclosure it’s a dry location on a solid surface.
Take care that none of the mounting screws will pierce any wiring harnesses, brake or fuel lines, the
vehicles fuel tank, spare tire or any other parts of the vehicle. Some or all of these may be located behind
or under the mounting surface.