Before starting your installation, thoroughly read this guide and keep it as a reference. It will give
you tips on proper placement, wiring, and installation as well as how to obtain the best sound from
the PowerBass speakers you have selected.
INSTALLATION EXPERIENCE
Installation of PowerBass Autosound Speakers requires experience with a variety of mechanical and electrical
procedures. This manual only provides general installation and operation instructions. If you have any reserva-
tions about your installation skills or lack of the proper tools, please contact your local PowerBass Autosound
dealer for assistance.
TIPS TO GET THE MOST OUT OF YOUR POWERBASS SYSTEM
Your PowerBass Autosound speakers have been meticulous engineered and designed to handle high power
musical reproduction. Despite their rugged construction, it is possible to damage your speaker if they are
improperly used. In general, you will hear distortion as a so-called warning before any damage occurs. If you
hear distortion in your system, immediately reduce the musical level to the point where the sound retains its
clarity.
1. Be sure you supply the speakers with enough unclipped amplifi er power to drive them properly.
(More
damage can be done to a speaker by under-powering and clipping your amplifi er than any other
way!)
2. Where possible, a separate amplifi er just for your speaker should be used with an electronic crossover to
set the frequency range. One amplifi er with passive crossovers will work (Tri-Way Setup), but the system
will do more with less stress on the amplifi er by using two amps.
3. To avoid any possible sound cancellation from the front of the speaker to that of the rear of the speaker,
cut a panel of Masonite or MDF to fi rmly mount the speaker if the vehicle’s original cutout is too big.
4. When connecting speaker wires from the amplifi er or head unit to that of the speaker itself, pay attention
to the polarity of the connection. This will insure optimum sound reproduction and performance.
5. For maximum dynamic performance use weather stripping to insure a tight seal.
6. Do not mount any speakers or external crossovers where they will get wet.
7. Remember the Golden Rule “Measure twice…cut once.”
