PowerBass ACS-1000D, Руководство пользователя

Страница: 3 / 24

3
TECHNICAL FEATURES
• High Efficiency Class D Design
• Mono Block Amplifier for Subwoofer
• High and Low Level Line Input
• MOSFET Power Supplies for High Power Output and Best Stability into Low Impedance Loads
• Soft Delay Remote Turn On/Off Circuit Eliminates Pops and Clicks
• Variable Low Pass Electronic Crossover
• Selectable Bass Boost EQ
• Self Diagnostic Protection Circuit with LED Status Indicator for; Impedance Over-load, Speaker Short
Circuit, Thermal Overheating, and DC Output.
• 1-OHM Stable Operation with Extensive Output Power Increase
• Variable Gain Control
• Remote Level Control Port(for optional controller)
INSTALLATION EXPERIENCE
Installation of PowerBass mobile amplifiers requires detailed knowledge of electronics wiring and proper
speaker impedance. We strongly recommend installation by an authorized PowerBass dealer. This Owners
Manual only provides general installation and operation instructions. If you have any reservations about
your installation skills, please contact your local PowerBass dealer for assistance.
IMPORTANT: This amplifier is designed for operation in vehicles with 12-volt Negative ground
electrical systems only.
PREPARING FOR INSTALLATION
NOTE: The tools listed below may be required for basic installation
• An electric drill with bits
• Philips head and standard screwdrivers
• Wire strippers
• Crimping tool
• VOM (electronic volt ohm meter)
• Heat shrink tubing and heat gun
• Soldering iron
• Electronic (Rosen Core not Acid Core) Solder