24
Maintenance and Storage
Replace the spool
WARNING!
Before replacing the spool, always switch off the machine
and take off the battery pack!
RISK OF INJURY!
Cutting elements continue to rotate after the
motor is switched off. Do not try to stop the cutting device (nylon
blade) with your hands. Always let it come to a stop by itself.
Remove the spool assembly from the trimmer. To do so, hold the
outer ribbed part of the assembly with one hand, while pushing
down and turning the spool head with the other to unlock it. The
spool carrier and spool will now disassemble easily.
Note:
There is a spring inside the head that could easily be lost.
Ensure that it is put in a safe place.
Choose either Option 1 or Option 2 below for spool or line
replacement.
Option 1: Replacing the spool
Insert the line from the replacement spool through the eyelet in
the spool carrier and slide the spool into it.
Making sure to insert the spring, assemble the spool and spool
carrier back onto the trimmer. To do so, push the head on and turn
it clockwise until it locks.
To test if the line is advancing properly, push the button with your
thumbs while pulling the line with your fingers. It should advance
freely.
Option 2: Replacing the line
WARNING!
Please use 1.2mm or 1.4mm diameter line only.
Line for your trimmer is available at extra cost from your local store
or the customer support service. Replace the line, as follows:
Insert one end of the line into the hole in the spool, about 3mm.
Wind the line tight and evenly onto the spool in the direction of the
arrow until the line builds up to the notches in the spool rim. Do
not overfill the spool. The spool holds about 6.5m of line.
