Troubleshooting
Please read th
ese
section
s
for troubleshooting before requesting repair services.
Trouble
Indicator status
No light
Lights on
See below
No dry air blow when hands put in.
Power Switch might be set to OFF
If so, set Power Switch to ON.
Has the circuit breaker been tripped?
If is OFF, Please reset it.
See page 3
Due to the location of Sensors, detection of hands is difficult in some
areas, including between Sensors and near the corners
Align fingers and put both hands fully into drying compartment .
If air blows,the dryer is working properly.
Has Filter accumulated dust or debris?
Clean Filter if these is an accumulation of dust or debris.
Is the ambient temperature within opetating temperature limits?
Set the temperature within
-1
0 to 4
0
℃。
Has something been placed inside the unit that could be blocking a sensor?
If there is something in the unit, remove it.
Is the sensor dirty?
If the sensor is not clean, wipe it with a soft damp cloth.
If the problem persists after the sensor is cleaned, the sensor is malfunctioning.
soltuions
Dryer not stopped when
hands removed
Warm air is not blown
Warm air is blown
The air volume is weak
Stopping 1-2 seconds after removing hands is normal.
Is the sensor dirty?
If the sensor is not clean, wipe it with a soft damp cloth.
Heater Power Switch might be set to OFF.
If so, set Heater Power Switch to ON.
Is the ambient temperature low?
The air might feel colder when the temperature is low.
(Only for the unit with aheater)Heater Power Switch might be set to ON.
If so, set Heater Power switch to OFF
Has Filter accumulated dust or debris?
Clean Filter if dust or debris has accumulated.
Is the ambient temperaure high?
The air might feel warmer when the temperature is high.
Is the dryer active for along time?
The air might become wamer if hand dryer is active for a long time
due to heat from the fan motor.
Clean filter if it has accumulated dust or debris.
Is the Fan Strength Switch set to Low?
Set the Fan Strength to High.
If the problem still prosists after preforming suggested actions, turn off the power switch and set
the breaker to
Off.
Please contact the supplier.
(only for units with a heater)
Light was flashing
Has Filter accumulated dust or debris?
Light was flashing
See below
See page
2
See page
3
See page 3
See page
10
See page
10
See page 3
See page
2
11
