10
Battery information
I ndicates the Battery capacity by 0-25% , 26-50% , 51-75% , and 76-100% .
I ndicates the battery is not connected.
I ndicates low battery level and low battery voltage.
I nput & Battery voltage information
I ndicates the input voltage or frequency or battery voltage.
Vac: I nput voltage, Vdc: battery voltage, Hz: input frequency
3- 3. Audible Alarm
Description
Buzzer status
Muted
UPS status
Bypass mode
Beeping once every 2 minutes
Yes
Battery mode
Beeping once every 4 seconds
Fault mode
Beeping continuously
Warning
Overload
Beeping twice every second
Yes
Others
Beeping once every second
Fault
All
Beeping continuously
Yes
3- 4. Single UPS Operation
3- 4- 1. Turn on the UPS w ith utility pow er supply ( in AC mode)
1) After power supply is connected correctly, set the breaker of the battery pack at “ON” position (the
step only available for long-run model). Then set the input breaker at “ ON” position. At this time
the fan is running and the UPS enter to power on mode for initialization, several seconds later, UPS
operates in Bypass mode and supplies power to the loads via the bypass.
NOTE:
When UPS is in Bypass mode, the output voltage will directly power from utility after you
switch on the input breaker. I n Bypass mode, the load is not protected by UPS. To protect your
precious devices, you should turn on the UPS. Refer to next step.
2) Press and hold the “ON” button for 0.5s to turn on the UPS and the buzzer will beep once.
3) A few seconds later, the UPS will enter to AC mode. I f the utility power is abnormal, the UPS will
operate in Battery mode without interruption.
NOTE:
When the UPS is running out battery, it will shut down automatically at Battery mode. When the
utility power is restored, the UPS will auto restart in AC mode.
3- 4- 2. Turn on the UPS w ithout utility pow er supply ( in Battery mode)
1) Make sure that the breaker of the battery pack is at “ON” position (only for long-run model).
2) Press the “ ON” button to set up the power supply for the UPS, UPS will enter to power on mode.
After initialization UPS will enter to No Output mode, then Press and hold the “ON” button for 0.5s
to turn on the UPS, and the buzzer will beep once.
3) A few seconds later, the UPS will be turned on and enter to Battery mode.
