POWER START 800 Скачать руководство пользователя страница 2

GB-2

GB-3

GB

GB

INDEX

1 STATE OF CHARGE LEDS
2 PUSH TO TEST BUTTON
3 CIGARETTE LIGHTER SOCKET
4 4-POLE CHARGER SOCKET
5 MAIN SWITCH WITH 12V OR 12/24V OPTION
6 12V OR 24V OUTPUT LEAD
Table 1: Part location refer to drawing on page 14

GENERAL

The Power-Start  range of portable power packs are designed to assist with starting 12 and 24 volt vehicles that
have discharged batteries. To ensure safe and trouble-free operation of your Power-Start  you must follow the
instructions below.

IMPORTANT INFORMATION

FOR YOUR SAFETY

DO NOT SHORT CIRCUIT OR TAMPER WITH THIS UNIT. ALWAYS OBSERVE CORRECT POLARITY AND
SYSTEM VOLTAGE WHEN CONNECTING.

Failure to do so may lead to a HAZARDOUS situation, damage the pack or the vehicle and may invalidate the
warranty. Remove personal items such as rings, bracelets and watches when working with a vehicle battery. Use
Power-Start for boosting standard 12 V or 24 V vehicle batteries only. Switch unit off when not in use.

WARNING

Before initial use, the Power-Start must be put on charge overnight (16Hrs). Failure to do so may reduce the life of
the product and invalidate the warranty.

CHARGING

CHECKING STATE OF CHARGE 

The state of charge is best checked 2 hours after charging. Ensure all cables are disconnected. Push the “Push to
test” button. The LEDs will indicate the approximate state of charge of the unit.

CHARGING THE POWER-START 

WARNING:

The 

POWER-START MUST BE IN THE OFF POSITION BEFORE

the charger is connected to it.

Ensure all output cables are disconnected. Failure to do so may damage the charger and will prevent the unit from
charging. 
Connect the charger plug to the 4-pole socket on the front of the unit. Plug the charger into the mains. The charger
LEDs will indicate when the unit is full, however,

the Power-Start must be left on charge when it is not being

used.

Only charge using the supplied charger. No other charger should be used as this may cause damage to the

batteries. Never leave the Power-Start discharged at any time. This may cause permanent damage to the batteries
and will invalidate the warranty.

CHARGING FROM A VEHICLE

Power-Start may also be charged from a 12 volt vehicle cigarette lighter socket by using the optional cigarette
lighter lead. This lead is designed to connect the charge socket on the Power-Start to the cigarette lighter on the
vehicle. The Power-Start will only be recharged slowly using this lead and only while the vehicle engine is running.
Therefore the pack should normally be recharged using the mains charger. Insufficient charging of the pack may
result in failure and this is not covered by the warranty.

STARTING & CONNECTIONS

STARTING VEHICLES

Always follow the vehicle manufacturer’s instructions for safe jump-starting. Check the voltage of the vehicle
system (12 V or 24 V). Ensure the Power-Start is in the "OFF" position. Switch off all lights and other loads on the
vehicle.

NOTE:

The pack will beep intermittently when connected or switched to 24 V. Connect to the vehicle system

observing correct polarity. The pack MUST be connected to the correct voltage and polarity of the vehicle system.

If the polarity is wrong a buzzer will sound continually. Reconnect correctly. Always check that the connection
polarity is right even if the buzzer does not sound.
Switch on Power-Start by turning the switch key to the correct position. Make sure cables are free of turning parts
of the engine and start the engine normally.

If the engine does not start within 6 seconds, stop and wait for

one minute before making a further attempt.

After the engine has started, allow it to run for a few minutes to

recharge the vehicle’s on-board battery. 

Switch off the engine then switch off the Power-Start and remove the negative clamp, then the positive clamp.
Restart the engine from the vehicle’s on-board battery.

NOTE:

It is not recommended that the Power-Start is used to start vehicles without a battery fitted or with a battery

that has had the electrolyte dried out. Damage may occur to the Power-Start or the vehicle if the Power-Start is
disconnected or switched off while the engine is running.

Содержание 800









Отзывы: