Power Sound Audio S1801, Руководство пользователя

Страница: 10 / 14

11
IEC AC CONNECTOR
The IEC AC CONNECTOR is where you connect the provided
power cord.
8
AMPLIFIER CONNECTIONS AND CONTROLS
POWER SELECTOR SWITCH
OFF
= The subwoofer amplifi er is powered down.
AUTO = Automatically powers up the subwoofer amplifer when
a signal is sent from your receiver or processor. If a signal is not
present, the subwoofer amplifi er is put into stand-by mode. The
subwoofer amplifi er will draw a negligible amount of current while
in stand-by.
ON = Turns on the subwoofer and leaves it on.
1
GAIN CONTROL
The GAIN control is used to adjust the output level of the sub-
woofer. This control should be set to achieve a similar acoustic
level as your loudspeakers. Proper calibration procedures should
be used to adjust the level of your subwoofer.
3
LED INDICATOR
GREEN
= The subwoofer is on.
RED = The subwoofer is in standby mode. The amplifi er will
enter standby mode after 13 minutes without a signal.
OFF = The subwoofer is off .
2
CROSSOVER CONTROL
The CROSSOVER control is used to minimze the output of the
subwoofer above the crossover’s setting. The crossover fre-
quency is variable from 40Hz to 150Hz, with an LFE mode when
turned fully clockwise.
5
DELAY CONTROL
The DELAY control is used to acoustically align the subwoofer
with the main speakers. The delay setting is variable from 0ms
to 16ms.
4
INPUTS
The subwoofer INPUTS consist of LEFT/LFE and RIGHT RCA
jacks. You only need to use the LEFT/LFE connection if you are
using a receiver or processor with an LFE or subwoofer output.
You can use a Y-connector on the subwoofer if it doesn’t power
up in AUTO mode at low levels. (
Please make sure to recalibrate
if you use a Y-connector.
)
7
ROOM SIZE CONTROL
The ROOM SIZE control is used to shape the lower end of the
subwoofers response to compensate for excessive room gain.
6