5
CHARGER STARTS UP IN READY MODE
-If the charger READY light comes on when you
first attach the battery (or in less than 13 hours) then the battery is probably more than
14.4 volts (12 cells). The charger resets into float mode when it detects a voltage over 21
volts. It will reach this voltage charging batteries over 15.6 volts (13 cells).
CHARGER WILL NOT SWITCH INTO FLOAT MODE
- If the charger will not switch into
the float mode, after 15 hours, check to see if there was a power interruption. A power
outage or glitch may have reset the charger timer for another 13 to 15 hour charge cycle.
CHARGE LIGHT ON WITHOUT A BATTERY
- This indicates that the output cable or
connector is shorted. If the light goes out with the output cable removed then you should
replace the cable. Do not attempt to charge a battery with a shorted output cable.
RATTLE
- If you think you hear a rattle inside the charger it is probably only a loose
terminal strip screw. Once the output cable is attached the rattle should go away.
Power-Sonic Corporation
7550 Panasonic Way,
San Diego, CA 92054
Tel: 619-661-2020
Fax: 619-661-3650
E-Mail: [email protected]
Website:http://www.power-sonic.com
