Power smart PS8810, Инструкция по эксплуатации

Страница: 7 / 21

7
Assembly instruction
WARNING: This plate compactor is heavy. Some procedures may require lifting equipment
or two people.
HANDLE ASSEMBLY:
•
The Plate Compactor is shipped with the lower handle already assembled and attached to the
plate.
• To complete the handle assembly, loosen the knobs in the middle of the handle and swing the
upper handle into place.
•
Next, insert the bolt, washer and nut into the hole directly above the plastic knob. Tighten the nut
and the plastic knob.
•
Repeat the process on the other side of the handle.
PREPARATION
ENGINE OIL RECOMMENDATIONS
CAUTION: Air cooled engines run hotter than automotive engines. The use of non-synthetic
multi-viscosity oils (5W-30,10W-30, etc.) in temperatures above 40°F will result in higher than normal oil
consumption. When using a multi-viscosity check the oil level more frequently than you would otherwise.
STEP 1 - FILL OIL
•
The plate compactor is shipped without oil. User must add the
proper amount of oil before operating the plate compactor for
the first time. The oil capacity of the engine crankcase is 20 fl.
oz.
• Select good quality detergent oil bearing the American
Petroleum Institute (API) service classifications SJ, SL, or SM
(synthetic oils may be used). Use the ASE viscosity grade of oil
from the following chart (Fig. 1) that matches the starting
temperature anticipated before the next oil changes.
FILLING CRANKCASE WITH OIL:
• Make sure the plate compactor is on a level surface.
Tilting the plate compactor to assist in filling will cause
oil to flow into engine areas and will cause damage. Keep
plate compactor level!
•
Remove the oil filler/dipstick cap from the engine.
• Using a funnel, add the appropriate type and amount of oil
into the crankcase. The crankcase is full when the oil level