Power smart PS3030, Инструкция по эксплуатации

Страница: 15 / 22

15
ON/OFF & SPEED CONTROL SWITCH
The Switch needs to have the Safety Key inserted before the Switch can be used. This feature prevents
unauthorized use of the Scroll Saw (See fig.5).

Insert Safety Key into Switch.

To turn Saw On, push Switch to the right.

To turn Saw Off, push Switch to the left.

Turn the Variable Speed Knob clockwise to increase the
stokes per minute.

To prevent accidents, turn off the tool, remove the Safety
Key, and unplug the tool from its electrical outlet after use.
Clean, then store the tool indoors out of children’s reach.
Store the Safety Key separately also out of children's reach.
ADJUSTMENT
Table angle adjustment
The Saw Table can be adjusted between 0 and 45 degrees as
follows (See fig.6) :

Loosen the Table Lock Knob and move the table until the
desired angle is reached as indicated on the Bevel Scale .

Tighten the Table Lock Knob.
Workpiece foot adjustment
When cutting at angles, the workpiece foot should be adjusted
so it is parallel to the table and rests flat above the work piece.

To adjust, loosen the screw, tilt the foot so it is parallel to the
table, and tighten the screw.

Loosen the workpiece foot lock knob to raise or lower the
foot until it just rests on top of the work piece. Tighten the
knob (See fig.7).
Dust blower adjustment
To adjust the dust blower , loosen the screw and adjust the blower
to the appropriate direction, then tighten the screw again (See
fig.8).
For best results, the dust blower tube should be adjusted to direct
air at both the blade and the work piece.
Fig.5
Fig.6
Fig.7
Fig.8