Power Probe Tek Pro Series, Инструкция по эксплуатации

Страница: 4 / 6

GETTING STARTED
CHARGING-
* Unit should be fully charged before first use. Allow 3 to 4 hours for a full charge.
* To charge plug the charger into any 100V-240V AC power source, such as a wall receptacle,
then plug the charger cord into the charging port on the base/charging module.
* Individual light modules must be installed into base/charging module to be recharged.
* The light rings on the lighting modules will glow red while the modules are charging.
* Allow the unit to fully charge until the charging indicating lights on the light modules turn
from red to green.
* Charge this light every month if not in constant use, and after each use when used often to
ensure battery longevity.
OPERATING-
* The light base/charging module has a master power button that controls all of the individual
light modules when they are installed in the base module.
* The unit has four individual and removable lighting modules that can operate independently
of the base module.
* Pressing the red tab beneath each lighting module releases the module from the base unit.
* To re-install the lighting module into the base unit, push into base unit slot until it latches.
* Press the button once for low brightness, twice for high brightness, and thrice to turn it off.
* If the individual modular lights become out of sync with each other, while all the modular
lights are in the base, press and hold the POWER button on the light base for 3 seconds. This
will re-sync all the light modules together.