AUTO CRIB-IT INSTRUCTION MANUAL
Page 8 of 9
POWER HAWK TECHNOLOGIES INC., Rockaway, New Jersey USA
Rev F 3/2013
Troubleshooting
Problem Possible
Cause
Solution
Extender Plates will not
rise automatically
Maximum extension has been
reached
Use block cribbing underneath the channel base
to raise the AUTO CRIB-IT starting height.
Ensure block cribbing supports the channel base
at a minimum of three points along its length
(each end and in the center). See section on
“Raising AUTO CRIB-IT Starting Height”.
Moving parts are dry and
require lubrication
Apply WD-40 generously to slide pin, fixed pin,
channel base slots, and hinge.
Insufficient
gas-spring
pressure
Replace gas spring assembly.
Parts are damaged
Determine damaged parts and replace as
necessary.
NOTE: A bent Slide Pin or Fixed Pin would
indicate that the
AUTO CRIB-IT
was overloaded.
Extender Plates will not
retract.
Load is still applied to the
AUTO CRIB-IT
See instructions on removing
AUTO CRIB-IT
Slide pin is still engaged in
channel base slot
See instructions on removing
AUTO CRIB-IT
Material or debris is lodged in
between Angle Supports
Remove material or debris from Angle Supports.
See instructions on removing
AUTO CRIB-IT
If the above does not correct problem, contact your authorized
AUTO CRIB-IT
Dealer or the Factory.
Replacement Parts:
Replacement parts for
the AUTO CRIB-IT
can be obtained from your authorized
AUTO CRIB-IT
Dealer or by contacting the Factory.
Specifications
Model AC-14
Model AC-17
Maximum Load:
2,000 lbs. (8.9 kN)
2,800 lbs. (12.4 kN)
Fully Extended Height:
13 in. (33.0 cm)
17 in. (43.2)
Weight:
14.5 lbs. (6.6 kg)
23.5 lbs. (10.7 kg)
Stowed Dimensions (LxWxH):
28 in. x 4 in. x 2-3/4 in.
36 in. x 6 in. x 3 in.
(71.1 cm x 10.2 cm x 7 cm)
(91.4 cm x 15.2 cm x 7.6 cm)
NOTE: The Angle Supports add 1-3/8 inches (3.5 cm) to the height at the center
The AUTO CRIB-IT™
is manufactured by:
POWER HAWK
®
Technologies, Inc.
300 Forge Way, Suite 2, Rockaway, New Jersey 07866 USA
1-800-PWR-HAWK
(1-800-797-4295) or 973-627-4646 Fax: 973-627-4622
www.powerhawk.com
“
Power Hawk
” is a Registered Trademark of Power Hawk Technologies, Inc.
“
AUTO CRIB-IT
” is a Trademark of Power Hawk Technologies, Inc.