AUTO CRIB-IT INSTRUCTION MANUAL
Page 6 of 9
POWER HAWK TECHNOLOGIES INC., Rockaway, New Jersey USA
Rev F 3/2013
TO REMOVE AUTO CRIB-IT…
7. Hold
the
AUTO CRIB-IT
handle down to prevent further extension and remove the applied load
from the Angle Supports.
8. Once the load is removed, lift the
AUTO CRIB-IT
handle upward to clear the slide pin from the
slots in the Channel Base and pull outward (toward the front of the
AUTO CRIB-IT
), while
pushing down on the Moveable Plate with your other hand at the same time. HINT: Apply toe
pressure to the front of the Channel Base to prevent the entire tool from moving.
NOTE: Avoid getting debris in between the Angle Supports which could get jammed and
prevent retraction.
9. Make sure Top Plates are all the way down and resting on the Channel Base. Re-engage AUTO
CRIB-IT Lock by turning the knob Counter-Clockwise as shown below. Test by pulling up on the
Top Plates to ensure the lock is properly engaged.
Toe
Pressure
Locking
Tab
Engaged
Make sure that the ¼-Turn Lock is in the UN-LOCKED
position when retracting the AUTO CRIB-IT. Failure
to comply will not allow the Top Plates to become
fully retracted and can cause the Locking Tab to
become loaded and bent. If the Tab becomes bent,
use pliers to straighten so that it properly engages
the upper part of the Channel slot when in the
LOCKED position.
!
CAUTION
WRONG!
When Retracting