Air Nibbler
5
Visit www.princessauto.com for more information
8036216
V 2.8
SPECIFIC SAFETY PRECAUTIONS
1. Keep hands and fingers away from the cutting area. Any body part coming in contact with moving parts
could cause injury.
2. When operating the air nibbler, use proper eye and hearing protection as well as protective heavy
work gloves.
3. To maintain complete control, firmly hold your air nibbler with both hands. Do not place hands over air
vents. Proper cooling of the motor is necessary to ensure normal life of the tool.
4. Never point the cutter towards yourself. If it should slip, part of your body could come in contact with
moving parts.
5. Never force the tool. Excessive pressure could bend or break the blades, resulting in damage to the tool,
your work piece or serious personal injury. If your air nibbler runs smoothly under no load, but does not run
smoothly under load, then excessive pressure is being used.
6. This tool will not stop moving immediately. Do not lay the tool down or leave it unattended until it has come
to a complete stop. A part that is moving could make the tool jump or grab a surface and pull the tool out of
your control.
7. Contact with a “live” wire will make exposed metal parts of the tool “live” and shock the operator.
8. After changing the die and cutter or making adjustments, make sure the die, cutter and any other adjustment
devices are securely tightened.
9. Remove adjusting keys and wrenches before turning the tool on. A wrench or a key that is left attached to a
rotating part of the tool increases the risk of personal injury.
10. Always check the die and cutter for damage before each use. A damaged die and cutter can break during use
and cause serious injury.
11. Never use a dull or damaged die and cutter. The die and cutter must be handled with care. A damaged die
and cutter can snap during use. A dull die and cutter requires more force to push the tool, possibly causing
the bit to break.
12. Never touch the die and cutter during or immediately after use. After use, the die and cutter will be too hot to
be touched by bare hands.
13. Always keep the air line away from moving parts on the tool.
