V1.0
20V 6-1/2 in. Li-ion Cordless Circular Saw
9049032
Visit www.princessauto.com for more information
13
INSTALL EXTERNAL BATTERY PACK
WARNING! Avoid unintentional starts by ensuring the trigger lock (A) is
engaged before installing the battery pack.
1.
Check the battery power level before each use.
a.
The battery is not fully charged out of the carton. Charge the
battery before first use.
2. Install the battery by aligning the rib on the battery with the groove
on the battery port and push forward until the latch clicks.
3.
Remove the battery by pushing the battery lock button and pulling the
battery free.
MOUNTING AND REMOVING THE BLADE
1.
Remove the blade
wrench from the handle
bracket located above
the motor.
2. Hold the spindle lock
button (K) down and use
the blade wrench to
loosen the blade bolt by
rotating clockwise.
Remove the bolt,
washer (Fig, 1-1) and outer flange (Fig. 1-2).
3.
Lift the lower guard (E) using the lower guard handle (D). Remove the
old blade (Fig. 1-3)
IMPORTANT! Do not remove the inner flange (Fig. 1-4).
4.
Install the new blade. Ensure that the directional arrow on the blade is
pointing to the same direction as the arrow on the upper guard (F).
5.
Place the outer flange on the spindle.
6. Hold the spindle lock button down and use the blade wrench to replace
the blade bolt and washer. Tighten securely.
7.
Replace the blade wrench on the handle bracket above the motor
ADJUSTING THE DEPTH
1.
Set the shoe (L) flat against the edge of the workpiece.
2. Raise the depth lever (N) to allow the cutting depth to be adjusted.
Fig. 1
1-1
1-2
1-3
1-4