8843534
5 in. Air Angle Grinder
V1.0
10
For technical questions call 1-800-665-8685
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents:
• Air Angle Grinder
• Wheel Guard
• Handle
• Wrench x 2
• Male Plug
IDENTIFICATION KEY
A
Handle
B
Wheel Guard
C
Body
D
Trigger Lever Safety
E
Trigger Lever
F
Air Inlet
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key
INSTALL AIR PLUG
Prepare a standard 1/4 in. NPT male air plug (sold separately) for use with your
tool.
1.
Wrap the external threads of the male plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2.
Screw the plug into the tool's air inlet and tighten with a wrench until snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the tool. A
quick coupler may then be used to connect the leader hose to the air line hose.
Fig. 1
