Power Fist 8823494, Руководство пользователя

Страница: 6 / 20

8823494 4 Ton Cable Puller with 3 Hooks V4.0
6 For technical questions call 1-800-665-8685
OPERATION
Letter references in parenthesis (A) refer to the included Identification Key.
You can set-up the cable puller with either a single or double line. Doubling the line
will decrease the effort needed to move the load, but it will move at half the speed.
1. Hook the cable hook (J) onto the load or pulling device (straps, chains,
etc.) and check that the latch is shut.
a. Double-Line option: Hook the pulley hook (K) onto the load or pulling
device (straps, chains, etc.) instead of the cable hook and check that
the latch is shut.
b. Hook the cable hook onto the anchor point (I) and check that the latch
is shut.
2. Press down on the drive pawl spring (E). The end of the spring will slide to
the slot’s bottom and raise the drive pawls (D).
3. Push the handle forward towards the cable hook (J). Push the stop pawls
(B) away from the ratchet drum’s teeth.
4. Pull out the amount of cable desired, leaving a minimum of three wraps on
the drum. Release the stop pawl and move the handle to the start position.
5. Clip the anchor hook (A) to a sturdy object capable of withstanding the
strain. Make sure the latch is fully shut.
6. Press upward on the drive pawl spring (E) to engage the drive pawls with
the ratchet teeth.
7. Raise the handle to force the pawls into the ratchet teeth and advance the
spool to draw the cable onto the puller’s drum. Lower the arm to reset for
the next pull.
8. Repeat until the load reaches its final position. Check that the cable is
wrapping neatly on the drum. Do not allow it to pile up on one side or to
overlap in the middle.
9. Disengage the pawls (steps 2 and 3) and pull the cable puller to release the
cable tension. Disengage the cable hook and anchor hooks.
10. Recover the remaining cable onto the drum.