8717035
115V Mini Utility Pump
V1.0
8
For technical questions call 1-800-665-8685
1.
Connect the supplied inlet hose (Fig. 1-2) to the pump’s inlet (H).
Connect a 5/8 in. discharge hose (Fig. 1-1) (sold separately) to the
pump’s outlet (E). The discharge hose should be as short as possible
and should not exceed 25 ft.
2. Position the pump on a surface that is stable, level, dry and not
slippery. Ensure that the inlet hose can reach the water source (Fig 1-4).
Do not exceed the pump’s maximum suction lift (Fig 1-3) of 3 ft.
OPERATION
NOTICE! The pump must be primed before use to prevent damage to
its mechanism.
1.
Prime the pump by filling the pump cavity with water through the
inlet (H). Ensure that the impeller (G) is fully submerged.
2. Dip the inlet hose into the water source. For best results, do not kink or
coil the hoses.
3.
Plug the power cord into an electrical outlet to turn the unit on.
4.
Unplug the unit once the water transfer is nearly complete. Do not
fully deplete the water source to prevent the pump from running dry.
CARE & MAINTENANCE
1.
Maintain the device with care. A device in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the device fittings, alignment, hoses and power supply cord
periodically. Have damaged or worn components repaired or replaced by
Fig. 1
