V1.0
High-Lift Hydraulic Transmission Jack
8667883
Visit www.princessauto.com for more information
7
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key.
1.
Connect the leg assembly (#2) to the main body (#11) by sliding a lock washer
(#4) and washer (#3) over each of the six M12x70 bolts (#5). Insert three bolts
through the leg assembly into the screw holes on the main body’s base.
Tighten each bolt until secure. Repeat with the other side.
2. Attach a caster (#1) to the end of each leg and secure with a lock washer
(#4), washer (#3) and nut (#6).
3.
Slide the Saddle (#21) onto the end of the ram (#15). Ensure the end is fully
in the saddle receiver, then secure with a M10x25 bolt (#18) through the
bolt hole in the receiver.
4.
Install the angle clamps (#22) onto the saddle. Align the hole in the bottom of
the angle clamp with the slot in the saddle. The clamp’s vertical part is
positioned to the outside of the saddle. Secure with an M10x25 bolt (#18),
washer (#20) and nut (#19). Secure the other angle clamp in the same manner.
5.
Attach two plates (#26) to each angle clamp (#22) with an M10x25 bolt
(#18), washer (#20) and nut (#19) for each plate.
6.
Insert an M10 screw (#25) into a plate’s top bolt hole from the outside. Secure
it with an M10 Nut (#19) and washer (#20). Repeat on a plate attached to the
other angle clamp. Attach a chain (#23) to each eye bolt with a shackle (#24).
7.
Insert a bar (#28) into the remaining plate on each angle clamp. Secure with
an M10 Nut (#19) and washer (#20). Insert an M8 Screw (#29) into the bar and
secure with a wing nut (#27).
8. Replace the screw on the main body (#11) with the air vent screw (#14).
OPERATION
LOWERING THE TRANSMISSION
Always transport the transmission in the lowered position with the chain
securely fastened.
1.
This jack is limited to the removal, installation and transportation in the
lowered position, of transmissions and differentials. Do not alter the jack
or adapters.
2.
Once the vehicle is secured and raised on a hoist, clear the area underneath
the vehicle of tools and people.
