V4.0
8 in. Variable Speed Bench Mount Buffer
8656860
Visit www.princessauto.com for more information
9
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
Contents:
• Bench Mount Buffer • 5/8 in.-11 Hex Nuts, 2 pc • Wheel Flange, 4 pc
• Spacer, 2 pc
• Sewn Wheel
• Soft Wheel
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
The buffer comes completely assembled with hex nuts (#1), wheel flanges (#2)
and spacers (#3) packed separately. One spiral sewn wheel and one soft wheel
are included.
INSTALL BUFFING WHEELS
Install the left, then the right buffing wheel onto the bench top buffer.
1. Remove the plastic protective sleeve from the left armature shaft.
2. Slide a spacer (#3) onto the left armature shaft.
3. Slide an inner wheel flange (#2) onto the armature shaft with the flat side
towards the buffing wheel.
4. Slide a buffing wheel on to the armature shaft and butt it against the inner
wheel flange.
5. Slide in the outer wheel flange (#2) and butt the flat side of the flange
against the buffing wheel.
6. Tighten the left-hand threaded hex nut (#1) on to the armature shaft. Make
sure the buffing wheel is firmly held in place and the hex nut is snug against
the outer wheel flange. Use additional spacers (not supplied) if required.
7. Repeat steps 1 to 6 to install a buffing wheel on the other side of the buffer.
Use the right-hand threaded hex nut (#21) for step 6.
