Visit www.princessauto.com for more information
5
8651598
V4.0
Soldering Iron
13. Heat up the soldering location with the soldering tip and add solder.
14. Let the soldering point cool down.
15. Clean the soldering tip on the wet sponge after each soldering.
16. After finishing the soldering, put back the soldering iron in the rack and turn off the
soldering station at the main switch.
17. Do not file off the soldering tip, or it will be damaged.
18. Never touch the hot soldering tip.
19. Let the soldering iron cool down after use.
20. The soldering iron may not be dunked into water.
21. During breaks, the soldering iron has to be placed in the holding rack.
MAINTENANCE
This tool must be placed on its stand when not in use.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid hazard.
TIP REPLACEMENT
Note: Tip replacement or cleaning should be done only when the iron is at room temperature
or below. The tip can be changed or replaced simply by unscrewing the knurled nut barrel
assembly. The station must be switched off and allowed to cool before and during this
operation, as damage may occur if the system is left on without the tip inserted, after removing
tip, remove any oxide dust that may have formed in the tip retaining area of the barrel. Be careful
to avoid getting dust in your eyes. Replace the tip and screw the retaining knurled nut barrel
assembly using only hand pressure to tighten. Pliers should only be used to tighten the nut if
loosening occurs when the iron is hot to avoid burning your fingers. Do not over tighten as this
would damage the element.
GENERAL CLEANING
The outer case of the iron or station may be cleaned with a damp cloth using small amounts of
liquid detergent. Never submerse the unit in liquid or allow any liquid to enter the case of the
station. Never use solvent to clean the case.
