8532293
Combination Belt and Disc Sander
V4.0
8
For technical questions call 1-800-665-8685
K Table Locking Knob
L Rubber Foot
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key. Dashed
numbers in parenthesis (Fig. 1-1) refer to a specific point in an illustration or image.
POSITIONING THE BELT AND DISC SANDER
1. Select a suitable work place before using the belt and disc sander. Your
work place should be well illuminated and enables you to attach a dust
collection system or a vacuum cleaner.
2. Place the belt and disc sander on a workbench or mount the sander on a
table with screws.
3. If this is not possible, use the included
rubber feet. If the rubber feet are not
attached, press them from the upper side
of the base through the edge openings.
MOUNTING THE
SANDING TABLE
1. Make sure the motor is switched off.
2. Thread the sanding belt (Fig. 1-1) through
the opening (Fig. 1-2) in the sanding table.
3. Tighten the sanding table (Fig. 2-1) with the
compatible nut and washer onto the screw
that sticks out from the housing. The locking
lever (Fig. 2-2) is still assembled. It is spring
loaded and can be repositioned. If you pull
out the handle, you can then change the
position of the handle without moving the
inside thread bar.
Fig. 1
Fig. 2
