Power Fist 8096000, Руководство пользователя

Страница: 6 / 16

12 in. Metal Shear
6
For technical questions call: 1-800-665-8685
8096000 V 2.6
OPERATION
NOTE: Before shearing, you can adjust the magnetic disc (#10) to press the work piece.
Maximum Cut Size
Thickness 1/4 in. (6mm)
Width 12 in. (300mm)
Flat Steel 2-3/4 in. x 1/4 in. (70mm x 6mm)
Rod Steel 1/2 in. (13mm)
1. When you shear the plate or bar listed in the above table, you must use the extension handle in
order to increase force.
2. Line up the material you wish to cut on the guideline.
3. When you want to shear, raise the handle (#8), the upper blade (#4) will raise up.
4. Insert the work piece, and then lower the handle (#8) to shear.
MAINTENANCE
1. Check for damaged parts. Before using any tool, any part that appears to be damaged should be
carefully checked to determine that it will operate properly and perform its intended functions.
Check for alignment and binding of moving parts, for broken parts or mounting fixtures, or for
any other condition that may affect proper operation.
2. Use only identical replacement parts or accessories intended for use with this tool when
servicing. Replace damaged parts immediately.
3. Keep the tool clean. Wipe the tool with a clean cloth and periodically blow out all areas with
compressed air. If compressed air is not available, use a brush to remove dust from areas. Do
not use harsh chemicals or solvents to clean the tool. These chemicals could seriously damage
the housing.
4. Regularly inspect all mountings and screws to ensure tightness. Should any screws become
loose, tighten immediately.
5. If repairs are required, bring your tool to Princess Auto Ltd.
LUBRICATION
Lubricate the rotating parts of the machine regularly.
DISPOSING OF THE TOOL
If your metal shear has become damaged beyond repair, do not throw it out. Take it to the appropriate
recycling facility.