Before you begin
Battery
The battery supplied with this product will not be fully charged. You need to
fully discharge the battery, then fully recharge for 3-5 uses prior to its full use.
Note:
For best results, completely discharge the battery after use.
To discharge battery
Simply operate tool continuously until the battery loses its charge.
Charging the battery with standard charger
1.
Plug AC adapter into a standard 120 electrical wall outlet.
2.
Plug jack from AC adapter into 120 VDC base.
3.
Insert battery into charger. Line up all 3 contacts.
4.
Push the “set” button to being charging.
Important:
A red LED light will come on when the battery begins charging.
Note:
After battery is completely charged, the charger will continue to “trickle”
charge the battery to its fullest charge.
Warning! To reduce the risk of fire, never leave battery unattended while
charging.
Inserting the battery
Important:
To avoid personal injury or property damage make sure the smart
switch is in the locked position prior to inserting the battery.
1.
The battery only inserts one way. Do not force the battery into the base of the
tool.
Note:
If you have trouble inserting the battery check to see if it is
properly aligned with the bottom of the tool.
2.
Push battery straight up (as shown) into the tool until it locks into place.
3.
To remove battery, press the Battery Release buttons on both sides
of battery and pull it straight down.
Power tool
Battery