2.9 GPM @ 2,500 PSI Electric Wall-Mount Pressure Washer
5
Visit www.princessauto.com for more information
8242273
V 2.9
Power Cord
1. Insert the power cord plug directly to the power supply whenever possible. Use extension cords or surge
protectors only when the tool’s power cord cannot reach a power supply from the work area.
2. Do not operate this tool if the power cord is frayed or damaged as an electric shock may occur, resulting in
personal injury or property damage.
a. Inspect the tool’s power cord for cracks, fraying or other faults in the insulation or plug before each use.
b. Discontinue use if a power cord feels more than comfortably warm while operating the tool.
c. Have the power cord replaced by a qualified service technician
3. Keep all connections dry and off the ground to reduce the risk of electric shock. Do not touch plug with
wet hands.
4. Prevent damage to the power cord by observing the following:
a. Never use the cord to carry the tool.
b. Do not pull on the cord to disconnect the plug from an outlet.
c. Keep the power cord clear of the tool and the tool’s work path while in operation. The cord should always
stay behind the tool.
d. Keep cord away from heat, oil, sharp edges or moving parts.
e. Do not allow people, mobile equipment or vehicles to pass over unprotected power cords.
i. Position power cords away from traffic areas.
ii. Place cords in reinforced conduits.
iii. Place planks on either side of the power cord to create a protective trench.
USE AND CARE OF TOOL
1. Use the correct tool for the job. This tool was designed for a specific function. Do not modify or alter this tool
or use it for an unintended purpose.
2. Do not carry the tool with fingers near or on the trigger/switch.
3. Avoid unintentional starts. Be sure that the ignition switch/trigger is in the neutral or OFF position when not in
use or before connecting it to any power source.
