Power Electronics NB WALL ADVANCED, Руководство по аппаратному обеспечению и установке

Страница: 25 / 54

POWER ELECTRONICS NB Wall
PREPARATION FOR INSTALLING THE EQUIPMENT
23
EN
PREPARATION FOR INSTALLING THE
EQUIPMENT
Site recommendations
When deciding the location of the equipment and planning its installation, it is recommended to follow a
series of guidelines derived from its characteristics.
CAUTION
To guarantee proper electrical installation, it is very important to comply with the bend radius of
the cable.
The customer must ensure the cables enter the equipment perpendicularly and the spacing
between them is appropriate.
Avoid corrosive environments that may affect the equipment´s proper functioning.
NOTICE
The instructions in this section do not, in any way, replace the mandatory regulations of the
country in which the equipment is to be installed.
Proper installation is absolutely necessary and it is not within the scope of the manufacturer's
responsibility.
Base site
The charger is designed to be installed on a wall or holder. Accordingly, certain site requirements must
be ensured for installation.
The customer is responsible for the correct dimensioning and execution of the installation in
accordance with current regulations.
•
The support surface for the equipment must be perfectly level and it must be thick enough to support
the equipment.
•
The sizing should be appropriate for the weight of the equipment and the characteristics of the soil.
•
If required, it must have acesses wide enough to ensure proper wiring passage (the suggested
cable access size is shown below).
•
It must not be a direct place of passage so that the load cables do not interrupt the movement of
pedestrians or traffic.
See anchor recommendations at the “
Anchoring of the equipment
”
section.
5